To display member utilization values and color-coded
design results on the structure, use the following procedure.
The utilization ratios for members
are only available for steel design performed in the batch mode. The
utilization ratio is for the load envelope used for design and is not affected by
the current load case in the Postprocessing workflow.
Note: For AISC
360-16, multiple parameter blocks (multiple steel designs)
can be reviewed in the user interface.
Tip: You can use the Design Results tab in the Diagrams dialog to display design result ratios even in the Analytical Workflow.
- Optional:
On the Results ribbon tab, select the parameter block or
maximum design from the Design Parameters drop-down
list.
If an input file contains multiple parameter blocks (steel design parameter
sets) or multiple design commands (steel code check or member selections) within
a single parameter block, then the results are available in the Postprocessing
workflow. Parameter sets are numbered and multiple design commands in the same
parameter block are given as decimals.
Note: This feature is compatible with AISC 360-16 only
in this release.
-
Either:
- on the Results ribbon tab, select
the tool in the View Results group.
- on the Results ribbon tab, select
the Utilization Ratio tool in the View
Results group
The utilization ratio label is shown next to each member
included in the steel design.
Note: Members are color coded:
green for passing design, blue for failing less than 50% over utilization,
and red for failing more than 50% over utilization.
The Design Results table
includes a tab for All members as well as for
Failed members.
- Optional:
Change the color coded limits:
-
On the
Results ribbon tab, select the
Structure tool in the
Configuration group.
The
Diagrams dialog opens.
-
Select the
Design Results tab.
-
In the color-coding table, change the
To cell values for the green and blue
rows.
For example, you may want to change the green (passing) utilization
ratio to 1.003 and the blue (nearly passing) utilization ratio to
1.05 to get a feel
for where the members are
nearly adequate.
-
Click
Apply.
The diagram color coding updates accordingly.
-
Click
OK.