Olet Placement
Olets are placed
on existing piping components either directly, or by first placing a tap port,
then placing an olet at the tap port location. The placement of olets without
using a tap port usually consist of the following common steps:
- Set the size and spec in the Standard Preferences dialog.
-
Select an option from the
Olets
gallery.
Note: If there is more than one record in the specification that meets the criteria, you are prompted to select a specific record from the Spec Record Selection dialog.
- Define the component settings in the Place Component dialog.
- Pick the component the olet is to be placed on.
- Use the mouse to pick a specific point on the pipe component to place the olet.
- Use the mouse to pick a rotation points for the olet.