Name
|
The name is used as reference in the segment. If different cross sections are used in the segment, the same link names may be used in different cross sections
|
Segment point step
|
The beam may be positioned within the cross section plane (0) or it may have a longitudinal component, i.e. the beam ranges from the current segment point to the segment point that is chosen by the step width.
|
Position1 and position 2
|
These positions defines the beam begin and end. If there is a cross section discontinuity at the segment point, the selection of before or after segment point is imported. Eccentric distances are determined by the specified node positions (s.below).
|
Part 1 and part 2
|
Part 1 and part 2 defines the positions of the beam nodes. Eccentric distances to the positions 1 and 2 are allowed. The used parts can be of type node or of type beam.
|
Eccentre 1 and eccentre 2
|
Eccentric distances in longitudinal directions.
Note: Presently not supported.
|