File
|
Select the file containing the results to be shown. After
clicking the arrow beside the list of the CALCULATED envelopes will be
displayed, select one of them.
|
El-No/Node
|
Element number (if 'Element' is selected) or node (if the 'Node'
is selected) to be displayed in the listing
|
Tendon
|
Number of tendon (if 'Tendon' is selected) for which the results
in the element division points will be shown.
|
Comb.
|
Select a combination, for which the results will be shown. Click
the arrow beside to open the list of possible superposition combinations.
|
Choice
Element/Node/Tendon
|
The results for elements, nodes OR tendons are displayed in the
listing.
|
Choice
Global/Local
|
The results in the list can be shown for the GLOBAL resp. LOCAL
element coordinate system.(only for Option Element/Tendon!).In case of Element
the local results mean the results in direction of element, the GLOBAL results
mean the results in direction of global coordinate system axis. In case of
tendons the local results mean the results in direction of elements, the GLOBAL
results mean the results in direction of tendons.
|
Ntel Pnt
|
The element results will be shown for begin and end point of the
element only. If an element subdivision is defined, the intermediate point
results can also be displayed by using the button NTEL.
|
Choice results:
total/primary/secondary
|
The results in the list can be shown for forces/stresses
|
Choice type:
normal/splitted/jointed
|
The results in the list can be shown for composite elements as:
- Normal - the results will be shown only for composite
elements
- Splitted - the results will be shown also for partial
elements of the composite element
- Jointed - the results for composite elements will be
represented as sum of partial element results and composite element result
|
Choice
RefSet
|
In case of stress list the reference-set can be chosen to find
the stress points for the Current cross-section of the element.
if there more than five stress points exist for
the current reference set, the option buttons > are activated!
|
ElemGrp
|
The results in the list can be shown for certain element group
After clicking the arrow beside the list all existing element groups will be
displayed.
|
PRINT
|
The button is used to print the screen list to the file. There is
possible to set the series and type of elements to be print out. If nothing is
set, the complete list will be print out.
|
MAX/MIN Value
|
To get the max/min value from the listing, one of six
displacements/forces has to be selected. There is possible to set the series
and type of elements, too. By using the MAXIMUM or MINIMUM button the program
find out the corresponding value and highlights the line in the listing.
To get the Max/Min values from the listing, one of the six
Displacements (Vx, Vy, Vz, Rx, Ry, Rz), Forces (Nx, Qy, Qz, Mx, My, Mz), or
Normal/Shear Stress (Sig XX, Tau YZ) should be selected. There is possible to
set the series and type of elements as well. By clicking on the Max or Min
button, the corresponding value will be highlighted in the listing .
Note: For Normal or Shear stress, Stress Leading Points need to
be selected from the drop-down menu.
|
DISPLACEMENTS / PRIMARY FORCES / SECONDARY FORCES/ TOTAL
FORCES
|
It is possible to toggle between the results for displacements,
internal primary, secondary and total forces. The listing will show all
corresponding values.
|