Plumbing Transition Properties

Property Name	Description
Connection 1 \| Length (L1)	`Positive <numeric value>` Sets the straight length at End1.
Connection 2 \| Length (L2)	`Positive <numeric value>` Sets the straight length at End2.
Connection \| End Type	fl `-<numeric value>` Sets and sizes end with a flange connection. m `-<numeric value>` Sets and sizes end with a male connection. fe `-<numeric value>` Sets and sizes end with a female connection. Separate End Type entries for each End Spec with a semi colon. Example: fl-2;fe-.13 creates a flange at End1 with size 2, and a female connection at End2 with an overall reduction of component's dimensions of .13
Inlet \| Outer Diameter	`Positive <numeric value>` Main outside diameter.
Outlet \| Outer Diameter	`Positive <numeric value>` Run outside diameter at End2.
Rise	`<numeric value>` Sets the top to bottom offset. Limited by Offset Options property.
Run	`<numeric value>` Sets the right to left offset. Limited by Offset Options property.
Offset Options	`<null value>` Frees fitting from any symmetry constraints. a `<angle value>` Face is offset by an angle value. a< `<angle value>` Changes the default minimum angle check of 5° to the New Value. b Bottom is flat. b `<numeric value>` Bottom is offset by value. ba `<angle value>` Bottom is offset by an angle. l Left side is flat. l `<numeric value>` Left side is offset by value. la `<angle value>` Left side is offset by an angle. r Right side is flat. r `<numeric value>` Right side is offset by value. ra `<angle value>` Right side is offset by an angle. s Fully symmetric fitting. st Symmetric fitting with respect to top and bottom. sr Symmetric fitting with respect to left and right. t Top is flat t `<numeric value>` Top is offset by value. ta `<angle value>` Top is offset by an angle. Combined entries are separated by forward slashes. Entries are honored in order from left to right. Angle value range is – 85° to + 85° unless a<xx° is encountered.
Total Length	`Positive <numeric value>` Sets overall length of main fitting.

Property Option menus are available to assist in making some property entries.