Circular Column Reinforcing
Column Info
Vertical Reinforcing
Setting | Description |
---|---|
General group |
|
Bottom / Top End Conditions | The following descriptions apply to both top and
bottom options.
Type – Select the type of end condition for each position:
|
Rotation | Type a rotation angle (in degrees). Click
![]() |
![]() |
When you select an end condition type, the standard
values and angle are applied. If necessary, click
Edit End Condition Values
![]() |
(Preview) - the cross section diagram | The diagram displays the current number of bars as specified from the Column Info tab. The bar arrangement buttons on the right side of the cross section diagram are used to assign each bar Label to various bar patterns in the cross section. |
![]() |
Vertical Reinforcement Patterns for Circular columns. Displays 3 patterns, each when clicked highlights the cross section illustration in the preview. |
![]() |
Adds a new line to the detail table and clears the
controls in the editing area allowing a new bar to be entered.
The table displays the details for each vertical bar type added to the reinforcing cage. |
![]() |
Deletes the current line from the corresponding table. |
Lap Options
Ties
Setting | Description |
---|---|
Zone Data |
|
Tie Data |
Extra turns Top: Specify the number of extra turns you want at the Top. Extra turns Bottom: Specify
the number of extra turns you want at the Bottom.
Lap Method:
|
![]() |
When you select an end condition type, the standard
values and angle are applied. If necessary, click
Edit End Condition Values
![]() |
![]() |
Adds a new line to the corresponding table and clears the controls in the editing area allowing a new tie zone or bar to be entered. |
![]() |
Deletes the current line from the corresponding table. |
![]() |
Change the location of the End Condition, can able to change the location of End condition of ties to the next location. |