• Type – Displays the currently selected end condition.
  Note: Some of the parameters are different for the selected end condition type. For example, the "User Type" will have settings both for start and end conditions.
• Load – Loads the default standard values for the current end condition type.
• Pin Dia (Pin Diameter) – Diameter of the pin used to bend the bar.
• Angle – The bend angle in degrees.
• Length – The leg length.
• Depth – The offset dimension from the end of a Crank to the main section of the bar.
• Tail/Leg – The tail/leg length. A tail/leg length is automatically calculated unless you manually enter a value using the Override Tail.
• Override Tail – When checked, enables setting a custom tail leg length.
• EC Reduction – When checked, applies the End Condition reduction.
• Rotation – Sets an angle to rotate the end condition.
• Rotate End Condition – Rotates all end conditions in 90° increments.

These properties associated with parts are taken when the model is processed, for example the Pin Diameters will also reflect in "Bar Bending Schedule".

• Manufacturer – Used to sets All or one of the mechanical device manufacturers from the drop-down list.
• Type – Used to filter the Device list, select a device type from the drop-down list:
  • All
  • Coupler
  • Terminator
• Device – Select the device in a given type for the selected manufacture to use from the list. A representative image of the selected device is shown to the right.
• Application – Select the desired application location from the drop-down list:
  • Manufacturer
  • Shop
  • Field
• Reverse – When checked, reverses the orientation of the device on the bar end.
• Screw Type – Sets the type of screw.
• Cost – Sets the unit cost of the device type.

• Manufacturer – Used to filter the Type list, select a mechanical device manufacturer from the drop-down list.
• Type – Select a device type from the drop-down list.
• Holdback – Set this option to include a length at the end of the bar with no preparation, using the specified length value in the adjacent field.
• Cost – Sets the unit cost.