To Save Database in PlantSight
-
In the OpenPlant Project Administrator CONNECT Edition,
Create a New WorkSet.
Enable Bentley Raceway and Cable Management for the WorkSet under Product Name in the OpenPlant WorkSet Creation Wizard dialog.
-
In the OpenPlant Project Administrator CONNECT Edition go to
CONNECT Services Tab and click
PlantSight.
The PlantSight Projects Portal webpage opens where you can launch PlantSight Essentials Projects.
- (Optional) If you don't already have connected Project, click Register. The Register a project webpage opens where you need to fill in all the Project Information.
- (Optional)
Click
Next.
The Pick Template Tab opens where you need to select the Project Template. If the Project Template is already selected, click Skip and Register to proceed.
The Project is registered successfully.
- If you already have a Project created, then select the existing Project.
-
Go to OpenPlant Project Administrator CONNECT Edition, select
your created WorkSet and then click
Associate on the
CONNECT Services ribbon Tab.
The Select CONNECT Project to Associate dialog opens.
- Select the Project and click Associate
- Enter the below configuration variables in the BRCM.cfg file at the WorkSets level C:\ProgramData\Bentley\OpenPlant CONNECT Edition\Configuration\WorkSpaces\OpenPlantExample\WorkSets\(WorkSet Name)\Standards\OpenPlant\BRCM and save the file.
- Launch Bentley Raceway and Cable Management and select the above created WorkSet.
-
Click
New File, enter
File Name, and then click
Save.
The newly created file opens.
- Place few raceways and then click Update Database on ribbon.
- In the iModel Console, select your Project from Listing all Contexts, iModel from Listing iModels from Project, and the named version from Listing named versions from iModel.
-
Enter the command in the textbox and click
Run.
For example, Enter the following command select * from racewaycablingdb.raceway to see the database table. Similarly, you can see other database tables.
You can check the record numbers by entering the following command select * from racewayscablingdb.userinfo in the textbox.