The Create Cross Section function creates a 2D
Microstation Model based on the cross section cut line selected by the user.
Boreholes can be on the cut-line or projected onto the cut-line. The unit of
the Offset in the dialog box is based on the Master unit that the model uses.
The Column width is the width of the borehole.
Note: The tool works only
with lines in the active model as it must edit the lines between a cross
section line and a cross section model to create links.
Note: To change the display direction in the Cross Section, use the
following Key In: CHANGE DIRECTION and then select the line and specify the new
direction to reverse it.
You can now create the cross section and the new direction will
be considered.
Key-in:
geotechnical section create