Used to specify the translational offset for moving a
the model origin.
Opens when the
Move Origin tool is selected in the
Node group on the
Geometry ribbon tab.
Note: All model geometry is updated relative to the new origin location.
Note: The controls in this dialog are analogous to the
Move Beams Selection dialog (opens with the
Move Beam tool is selected), the
Move Plates Selection dialog, and the
Move Solids Selection dialog.
Setting | Description |
---|
By distance between following nodes
|
Uses two node numbers and determines the vector between them. The
origin is shifted along a parallel vector of the same distance.
|
By following X, Y and Z values
|
uses the Cartesian coordinates specified to create a vector
|