TR.26.1 Define Material
This command may be used to specify the material properties by material name. You will then assign the members and elements to this material name in the CONSTANTS command (See
TR.26.2 Specifying Constants for Members and
Elements for details and an example).
General Format
DEFINE MATERIAL
then
ISOTROPIC name
E f1
G f3
POISSON f6
DENSITY f7
ALPHA f8
DAMPING f10
TYPE { STEEL | CONCRETE | ALUMINUM | TIMBER }
or
2DORTHOTROPIC name
E f1 (f2)
G f3 (f4) (f5)
POISSON f6
DENSITY f7
ALPHA f8 (f9)
DAMPING f10
TYPE { STEEL | CONCRETE | ALUMINUM | TIMBER }
Repeat ISOTROPIC or 2DORTHOTROPIC name and values for as many materials as desired then:
END MATERIAL (DEFINITION)
Where:
Parameter | Description |
---|---|
name | material name (name of up to 36 characters) |
f1, f2 | specifies Young's Modulus (E). (f2 in local Y for 2DOthotropic materials). f1 defaults to 0.0, but a positive value must be entered or an error will ensue. f2 defaults to f1 |
f3, f4, f5 | specifies Shear Modulus (G). For plates, the following
are G values in local directions: f3 is the G for in-plane shear; f4 is the G for transverse shear in the local Y-Z direction;
f5 is the G for transverse shear in the
local Z-X direction. (Enter only for beams when the Poisson ratio is
not in the range of 0.01 to 0.499.) If f3 is not entered, then this value is calculated as G = 0.5×E/(1 + ν) (i.e., caluclated based on Young's modulus and Poisson's ratio). f4 defaults to f3 and f5 defaults to f4. |
f6 | specifies Poisson's Ratio (ν). This value must be in
the range of 0.01 to 0.499. Poisson's ratio must be entered for orthotropic
plates or when Poisson cannot be computed from G. For Isotropic materials, this value defaults to a sliding scale
value based on E:
|
f7 | specifies weight density (γ). Defaults to 0.0 |
f8, f9 | Coefficient of thermal expansion. Defaults to 0.0. (f9 in local Y for 2DOthotropic materials, defaults to f8.) |
f10 | the damping ratio to be used in computing the modal damping by the composite damping method in a dynamic analysis when CDAMP has been specified. Damping must be in the range of 0.001 to 0.990. Defaults to 0.0 |