General
Format
PRINT HARMONIC DISPLACEMENTS list-spec
list-spec = { (ALL) | LIST list of items-joints }
This command must be after all steady state/harmonic loadings and before the
END STEADY command.
For each harmonic frequency of
the output frequencies specified the following will be printed:
- Modal responses
- Phase angles with 1
line per selected joint containing the phase angle for each of the 6
directions of motion
- Displacements table
with 1 line per selected joint containing the maximum displacements for each
of the 6 directions of motion
- Velocities
- Accelerations
Steady State
Notes
For members, the final results at the joints will be
complete but the section results will be as if the member loads were applied as
statically equivalent loads at the member ends.
