TR.37.6.5 Steady Force Loading

This set of commands may be used to specify JOINT loads on the structure, the forcing frequency, the modal damping, and the phase relationship of loads in each of the global directions.

General Format

This command specifies the forcing frequency and damping for a case of steady forces.

STEADY FORCE FREQ f1 { DAMP f2 | CDAMP | MDAMP }

Where:

Parameter	Description
FREQ f1	the steady state frequency in cycles/sec at which the joint loads below will oscillate.
DAMP f2	Damping ratio for all modes when `DAMP` is selected. Default value is 0.05 (5% damping if 0 or blank entered).

DAMP, MDAMP, and CDAMP select source of damping input:

DAMP indicates to use the f2 value for all modes
MDAMP indicates to use the damping entered or computed with the DEFINE DAMP command if entered, otherwise default value of 0.05 will be used
CDAMP indicates to use the composite damping of the structure calculated for each mode. You must specify damping for different materials under the CONSTANT specification

Joint Loads

Refer to TR.32.1 Joint Load Specification for additional information on Joint Loads

JOINT LOAD ( [ PHASE *{ X | Y | Z } f7] )

Where:

Parameter	Description
PHASE f7	Phase angle in degrees. One phase angle per global direction.

Bracketed data may be entered for each global direction on the same line. All moments specified below will be applied with a phase angle of 0.0. All forces specified below will be applied with the phase angle specified above, if any. Default is 0.0.

Next are the joint forces, if any. Repeat as many lines of joint force data as needed.

joint-list *{ FX f1 | FY f2 | FZ f3 | MX f4 | MY f5 | MZ f6 }

Where:

Parameter	Description
FX f1, FY f3, FZ f3	specify a force in the corresponding global direction.
MX f4, MY f4, MZ f6	specify a moment in the corresponding global direction.

Notes

Joint numbers may be repeated where loads are meant to be additive in the joint.
UNIT command may be on lines in between joint-list lines.
Forces applied at a dependent degree of freedom will be ignored.

Copy Loads

The next command, Copy Load, may optionally be placed here to use the equivalent joint loads from prior cases. This feature enables using the more complex loading commands like selfweight, floor load, wind load, etc. that are not directly available here.

COPY LOAD

i₁, f₁, i₂, f₂ ... i_n, f_n

Where:

Parameter	Description
i₁, i₂ ... i_n	prior primary load case numbers that are in this analysis set.
f₁, f₂ ... f_n	corresponding factors

This command can be continued to additional lines by ending all but last with a hyphen. These cases must have been between the Perform Steady State Analysis command and the prior Analysis command (if any).