P. Built-Up Sections in Steel AutoDrafter
Steel AutoDrafter recognises and draws built-up sections. These sections have to be defined in STAAD.Pro, using a particular format within the user table section.
| Section | User Table Prop Name |
|---|---|
| Angle Star | AS-ISA75X75X8-10 |
| I/H Star | IS-ISMB500 |
| Built Up I | IBU-DPT-WD-WT-FT |
| Built Up Channel | CBU-DPT-WD-WT-FT |
| Two I/H Sxn | 2I-ISMB250-100 |
| = | ||
| = | ||
| = | ||
| = |
- "10" in the Angle Star represents the clear gap between the two angles.
- "100" in the 2I represents the clear gap between the two sections.
Example of creating user table in STAAD as per above format:
START USER TABLE
TABLE 1
UNIT CM MTON
GENERAL
IEU-750-250-12-20
185.2 75 1.2 25 2 169049 5218.56 85.28 4507.98 417.48 0 0 0 0 0 0
IS-ISMB200
61.6 20 0.57 10 1 2257 14 225.7 451.4 0 0 0 0 0 0
AS-ISA75X75X6-8
17.32 15 0.58 15 0.58 192.58 148.6 1.97 33.62 28.02 12.99 12.99 51.47 -
44.04 19690.9 13.84
2I-ISMB200-200
64.66 20 1.62 30 1.07 6766 4470.8 21.85 451.067 447 48.49 48.49 656.48 -
517.95 218592 16.76
END