M. To insert a round opening
Use the following procedure to insert a round hole by one of two means.
A hole is an interior contour which is parametrically defined with a center and radius. You may specify a radius by an exact value or by drawing in the View window, depending on your tool selection.
- Select either If you selected to specify a radius, the Radius of the circle hole dialog opens.
- If you selected to specify a radius, enter the value and click OK in the Radius of the circle hole dialog.
- Click a point to define the center of the circular hole. If you are defining the radius graphically, a circle is rubber-banded to the mouse pointer. Otherwise, the hole is drawn with the previously specified radius.
- Double click a point to define a radius. The hole is drawn.
- Exit the hole drawing mode by either
