The purpose of code checking is to check whether the provided section properties of the members are adequate to carry the forces transmitted to it by the loads on the structure. The adequacy is checked per the DIN requirements.

Code checking is done using forces and moments at specified sections of the members. If the BEAM parameter for a member is set to 1, moments are calculated at every twelfth point along the beam, and the maximum moment about the major axis is used. When no sections are specified and the BEAM parameter is set to zero (default), design will be based on member start and end forces. The code checking output labels the members as PASSed or FAILed. In addition, the critical condition, governing load case, location (distance from start joint) and magnitudes of the governing forces and moments are also printed.

コードチェックの一般的な情報については、「 D1.B.1.3 Code Checking」を参照してください。コードチェックコマンドの仕様の詳細については、「TR.49 コードチェックの設定」を参照してください。