STAAD.Pro Help

M. To check for warped plates

A warped plate is defined as a four-noded plate whose nodes do not lie on the same plane. This tool detects such plates.

You can set the tolerance for warped plates by first setting the Tolerance for Warped Plate Element Detection value on the Options dialog Tolerance tab. Only plates whose angular deviation exceeds this tolerance value will be displayed.

For this check, warping is defined as excessive angular deviation between all vertex normals.

  1. Select one or more plates in the model.
  2. Select the Plate Tools >  Check for Warped Plates tool in the Geometry Tools group on the Utilities ribbon tab.

    If any warped plates are detected, the Detect Warp Plates dialog opens. A list of all selected plates and their maximum angular deviation is displayed. The global coordinates for a selected plate are displayed below.

  3. (オプション) Click Highlight
  4. (オプション)  Click Delete
    ヒント: You can undo this action through the Undo tool in the main interface.
  5. Click Close when you have completed reviewing warped plates.

An example of such an element is demonstrated in the following STAAD input.

1 0 0 0; 2 0 10 0; 3 10 10 0; 4 10 0 2
21 1 2 3 4

Nodes 1, 2, and 3 lie in the XY plane at Z = 0, but node 4 has a Z coordinate of 2, thereby causing the plate to become non-planar.

The warped plate check sub-divides the quad element into two sets of triangles: one with a diagonal from point 1 to point 3 and another diagonal from point 2 to point 4. These triangles do not lie in the same plane so an angle is formed between them at their shared edge. The largest angle between adjacent triangles in the warped quad element is compared against the tolerance threshold. If this tolerance angle is exceeded, then the plate is reported as excessively warped.

A) Checking triangles formed by the diagonal 2-4.

B) Checking triangles formed by the diagonal 1-3