Used to apply nodal loads.
The following options are available under this tab:
Node
| 設定 | 説明 |
|---|
|
Fx/Fx',
Fy/Fy',
Fz/Fz'
|
Type values of the forces in corresponding global
directions or inclined axis (') directions when the
Inclined Load? option is checked. A negative
sign (-) may be used.
|
|
Mx/Mx',
My/My',
Mz/Mz'
|
Type values of the moments about the corresponding
global directions or inclined axis (') directions when the
Inclined Load? option is checked. A negative
sign (-) may be used.
|
| Inclined Load?
|
Check this option to specify the load along an inclined
coordinate system. An inclined coordinate system is defined by an X' axis that
pass from the loaded joint through a reference point. That reference point can
be defined either a reference node, a set of absolute (global) coordinates, or
a set of relative distances from the loaded joint.
注記: When this option is checked, the load vector labels are
updated to reflect the inclined (') vector.
|
| Inclination
|
Select the option used to define the inclined coordinate system.
- Reference
Node - select an existing node number from the model. The global
coordinates of that node are displayed as read-only.
- Absolute - type
the global coordinates of an arbitrary point to use as the reference.
- Relative - type
relative distances from the loaded joint to the reference point. These
distances are measured along the global axes.
参照点は、絶対座標、相対距離、参照ジョイントのいずれを使用して指定した場合も、荷重ノードから参照点へのx'軸の方向を定義します。Y'軸の方向は、X'とYの平面上のx'に垂直な方向として定義されます。X'がYの方向にある特殊なケースでは、Y'はZの方向になります。Z'の方向は、X'とY'の平面に垂直な方向として定義され、STAAD.Proで使用される他のすべての座標軸系と同様に右手系の規則に従います。
|
Support
Displacement
Used to specify a support displacement. Multiple support
displacements may be used for a single load case, but each support value and
direction must be entered independently.
| 設定 | 説明 |
|---|
| Displacement
|
Specify the value of the displacement. A negative
sign (-) may be used.
|
| Direction
|
Select the direction of the displacement as
Fx,
Fy, or
Fz (translational), or
Mx,
My, or
Mz (rotational).
|
