TR.0 STAAD Commands and Input Instructions
Although the STAAD.Pro input can be created through the Analytical Modeling workflow, it is important to understand the command language. With the knowledge of this language, it is easy to understand the problem and add or comment data as necessary. The general sequence in which the commands should appear in an input file should ideally follow the same sequence in which they are presented in this section. The commands are executed in the sequence entered. Obviously then the data needed for proper execution of a command must precede the command (e.g., Print results after Perform Analysis). Otherwise, the commands can be provided in any order with the following exceptions.
- All design related data can be provided only after the analysis command.
- All load cases and load combinations must be provided together, except in a case where the CHANGE command is used (see TR.38 Change Specification). Additional load cases can be provided in the latter part of input.
All input data provided is stored by the program. Data can be added, deleted or modified within an existing data file.
In-Core Verus Out-of-Core
The engine can operate in two modes: in-core and out-of-core. The in-core solver will be used for models with under 20,000 joints and the out-of-core solver for models over 20,000 joints. In most situations, the in-core mode will provide the quickest solution, but where there is insufficient memory available, then the engine will use the out-of-core mode. Again, selection of the mode is automatically chosen by the analysis, but can be overridden using the SET STAR command.
The full set of overrides for the advanced engine is:
- SET STAR 3 – default
- SET STAR 4 – use out-of-core solver regardless of size