Column / Pedestal Depth
|
Specify a column (or pedestal, if height is specified) depth (dimension parallel to the X axis), in the selected units.
Note: Pedestal Design is support for US (ACI 318) code only.
|
Column / Pedestal Width
|
Specify a column (or pedestal, if height is specified) depth (dimension parallel to the Z axis), in the selected units.
|
Strength of Concrete
|
Specify the ultimate strength of the concrete (f'c), in the selected units.
|
Wt of Concrete
|
Specify a density to be used for concrete (wC), in the selected units.
|
Yield Strength of Steel
|
Specify the yield strength of steel reinforcing bars (fy), in the selected units.
|
Side Cover (Cs)
|
Specify a concrete clear cover distance to be used for the sides of the pile cap reinforcement, in the selected units.
|
Bottom Clear Cover (Cb)
|
Specify a concrete clear cover distance to be used for the bottom-most layer of pile cap reinforcement above the piles, in the selected units.
|
Pile in Pile Cap (Cp)
|
The distance from the bottom of the pile cap to the top of the piles, in the selected units.
|
Initial Thickness
|
The minimum thickness used in design, in the selected units.
|
Minimum / Maximum Bar Spacing |
Specify the minimum and maximum distances to be allowed between reinforcing bars, in the selected units.
|
Pedestal Height
|
Height of a pedestal used at the support, taken from top of pile cap, in the selected units.
|
< Previous
|
Steps the Wizard to the previous step.
|
Next >
|
Proceeds the Wizard to the next step.
|
Cancel
|
Exits the Wizard without creating a new Pile Cap Job.
|