Skip to main contentSkip to docs navigation

RAM Elements Truss Design Module Help

RAM Elements Truss Design Module Help
  • Truss Design Module Help
    • General commands of the worksheet
    • Keyboard Shortcuts and Mouse Operations
    • Truss supports
    • Member properties
    • Member splices
    • Concentrated forces
    • Distributed Loads
    • Steel design criteria for AISC 360
    • Steel design criteria for AISI
    • Steel design criteria for AS 4600
    • Steel design criteria for BS5950 - 2000
    • Steel design criteria for AS 4100 -1998
      • RSC (Residual stress category)
      • BHA (Bolt holes area)
      • Betam33
      • Betam22
      • FLR (Full Lateral restraint)
      • RA Top (Restraint arrangement top)
      • RA Bot (Restraint arrangement bottom)
      • LLP (Load longitudinal position)
      • LHP (Load height position)
      • LRR Top (Top ends with lateral rotation restraints)
      • Lb Top (Top unbraced length for bending)
      • Lb Bot (Bottom unbraced length for bending)
      • s (Spacing between stiffeners)
      • kt
      • lz
    • Steel design criteria for CSA S16
    • Steel design criteria for NBR 8800
    • Wood design criteria for NDS
    • Reports
    • Optimization
    • Create/Edit Sections
    • Edit or create a load combination
    • Delete load conditions
    • Generate load combinations
    • Databases editing commands
  1. Truss Design Module Help
  2. Steel design criteria for AS 4100 -1998
  3. FLR (Full Lateral restraint)

FLR (Full Lateral restraint)

This check sets the designed member as Fully Lateral Restrained without the need of the checks defined in Clause 5.3.2.