Define the latitude tendons Pt. 6

Complete the steps in "Define the latitude tendons Pt. 5" before proceeding.

With the Selection tool (), select the tendon segments between D-2 and D-3.
Click the Calc Profile tool (). The Calc Tendon Profile dialog box appears and reports the current balance load is -5.27 kN/m. If this is not the number then you probably selected only one tendon segment.
Click Cancel.
With the Selection tool (), select the tendon between C-3 and C-4.
Click the Calc Profile tool ().
Input the desired balance load as -5.3 kN/m in the Calc Tendon Profile dialog box and click Calc. The low point (end 2) adjusts to 128 mm.
With the Selection tool (), select all the end span tendons between grids 3 and 5.
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 2 to 125 mm and click OK.
Note: These steps first used the Calc Profile tool to determine a low point that produces a similar average uplift in an end span as the adjacent span, and then manually changed the low points for practical reasons.
Finally, you need to adjust the tendon that goes through the opening.

Proceed immediately to "Define the latitude tendons Pt. 7".