Define the manual latitude tendons Pt. 2

Complete the steps in "Define the manual latitude tendons Pt. 1" before proceeding.

With the Full Span Tendon Panel tool () selected, draw tendons in the bottom left panel:
1. Click at the center of the column at grid intersection A-1.
2. Click at the center of the column at A-2.
3. Click at the center of the column at B-2.
4. Click at the center of the column at B-1.
In the Tendon Panel dialog box:
1. Set Tendon Spacing to Equal.
2. Set Spacing to 2 m, and click OK.
With the Full Span Tendon Panel tool () selected, draw tendons in the next panel:
1. Click at the center of the column at grid intersection B-1.
2. Click at the center of the column at B-2.
3. Click at the center of the column at C-2.
4. Click at the grid intersection C-1.
In the Tendon Panel dialog box:
1. Set Tendon Spacing to Equal.
2. Set Spacing to 2 m,
3. Check Skip start tendon, and click OK.
With the Full-Span Tendon Panel tool () selected, draw tendons in the next two panels:
1. Click at the center of the column at grid intersection A-2.
2. Click at the center of the column at A-3.
3. Click at the center of the column at C-3.
4. Click at the center of the column at C-2.
In the Tendon Panel dialog box:
1. Set Auto Connect.
2. Uncheck Skip start tendon, and click OK.
Turn off Snap Orthogonal ().
With the Full-Span Tendon Panel tool () selected, draw tendons in the next panel:
1. Click at the center of the column at grid intersection B-3.
2. Click at the center of the column at B-5.
3. Click at the center of the column at C-4.
4. Click at the center of the column at C-3.
In the Tendon Panel dialog box:
1. Set Auto Connect, and click OK.
With the Full-Span Tendon Panel tool () selected, draw tendons in the next panel:
1. Click at the center of the column at grid intersection C-2.
2. Click at the center of the column at C-3.
3. Click at the center of the column at D-3.
4. Click at grid intersection D-2.
In the Tendon Panel dialog box:
1. Set Tendon Spacing to Equal.
2. Set Spacing to 2 m.
3. Check Skip start tendon, and click OK.
With the Full-Span Tendon Panel tool () selected, draw tendons in the next panel:
1. Click at the center of the column at grid intersection C-3.
2. Click at the center of the column at C-4.
3. Click at the center of the column at D-4.
4. Click at the center of the column at D-3.
In the Tendon Panel dialog box:
1. Set Auto Connect.
2. Uncheck Skip start tendon, and click OK.
Note: Auto-connect will ignore the tendons at the first click because there are already two tendon segments connected at that point.

Proceed immediately to "Define the manual latitude tendons Pt. 3".