Define the manual longitude tendons Pt. 3
- With the Full-Span Tendon Panel tool () selected, draw tendons in the next panel: This sequence is counterclockwise.
- In the Tendon Panel dialog box:
- With the Full-Span Tendon Panel tool () selected, draw tendons in the next panel:
- In the Tendon Panel dialog box:
- With the Full-Span Tendon Panel tool () selected, draw tendons in the next panel:
-
In the Tendon Panel dialog box:
Note: Auto-connect will ignore the tendons at the first click because there are already two tendon segments connected at that point.
The panel in the top right has too many tendons and some should be deleted.
- Select the second tendon in this panel.
- Hold down <Shift> and select the fifth tendon in this panel, and press <Delete>.
-
With the Half Span Tendon Panel tool () selected, draw tendons that terminate in this panel:
- Turn on Snap Orthogonal ().
- Click at the profile point at 63.2, 58 ft.
- Type r0,7.
- Click at the last tendon profile point at 72.8, 58 ft.