Define the latitude tendons Pt. 2

Complete the steps in "Define the latitude tendons Pt. 1" before proceeding.

With the Tendon Polyline tool () selected, draw a tendon along grid A:
1. Click at the center of the column at grid intersection A-1.
2. Click at the center of the column at A-2.
3. Click at the center of the column at A-3.
4. Right click, and then click Enter.
Turn on Snap Orthogonal ().
With the Tendon Polyline tool () selected, draw a tendon along grid D:
1. Click at the center of the column at grid intersection D-4.
2. Click at the center of the column at D-3.
3. Click at the corner of the slab near D-2.
4. Right click, and then click Enter.
Turn off Snap Orthogonal ().
Double click the Tendon Polyline tool () to edit its default properties.
In the Default Tendon Properties dialog box:
1. Set Strands per Tendon to 20, and click OK.
With the Tendon Polyline tool () selected, draw a tendon along grid B:
1. Click at the center of the column at grid intersection B-1.
2. Click at the center of the column at B-2.
3. Click at the center of the column at B-3.
4. Click at the center of the column at B-5.
5. Right click, and then click Enter.
With the Tendon Polyline tool () selected, draw a tendon along grid C:
1. Click at the center of the column at grid intersection B.8-1.
2. Click at the center of the column at C-2.
3. Click at the center of the column at C-3.
4. Click at the center of the column at C-4.
5. Right click, and then click Enter.

Proceed immediately to "Define the latitude tendons Pt. 3".