JavaScript must be enabled in order to use this site.Please enable JavaScript in your browser and refresh the page. Add drop caps Enter the dimensions for a drop cap at Supports 2 and 4 in the Drop Caps table (top table) on the Drop Cap and Drop Panels page. Set the drop cap data as follows For Support 2 in the Drop Caps table set the following values: Set the thickness to 20 inches [500 mm]. Set the left width to 22.5 inches [600 mm]. Set the right width to 22.5 inches [600 mm]. Set the before length to 22.5 inches [600 mm]. Set the after length to 22.5 inches [600 mm]. For Support 4 in the Drop Caps table set the following values: Set the thickness to 20 inches [500 mm]. Set the left width to 33 inches [900 mm]. Set the right width to 12 inches [300 mm]. Set the before length to 33 inches [900 mm]. Set the after length to 0 inches [0 mm]. Click Next to proceed to the Loads page. Parent topic: Strip Wizard Tutorial