Define the manual latitude tendons Pt. 5
- With the Selection tool (), double click the tendon segment at B-2.
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, set Profile at end 1 to 462 mm and click OK.
- With the Selection tool (), double click the tendon segment at C-2.
- Hold down the <Shift> key, and double click the tendon segment immediately below (profile point at (9,15.7)).
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, set Profile at end 1 to 162 mm and click OK.
- With the Selection tool (), select the tendon segments between D-2 and D-3.
- Click the Calc Profile tool (). The Calc Tendon Profile dialog box appears and reports the current balance load is -5.67 kN/m. If this is not the number then you probably selected only one tendon segment.
- Click Cancel.