Recursion too deep

If the mesh ends up with 3 nodes at a tight angle, RAM Concept attempts to use recursion numerous times to adjust the nodes and make the minimum angle larger. In such a case, the standard number of recursions did not solve the tight angle, so the warning message reported that the recursion was too "deep".

This does not generally cause a problem, although it is indicative that there is a "pointy" element which can affect the contour plots. Generally, it is best to avoid this situation. See "Feature eliminated at (x,y)".

Note: You should investigate the meshing / modeling of the problem area to ensure that Concept's elements are reasonable for the area.

Note: This error is usually caused by a failure to use snapping while drawing: two lines that are supposed to be in the same place are instead slightly off parallel and intersect.