Define the longitude profile polylines Pt. 2
Complete the steps in
"Define the longitude profile polylines Pt. 1" before proceeding.
-
Choose the Move tool (
).
-
Hold down the <Shift> key, click anywhere on the plan, and type r0,-0.75.
-
Select the profile polyline between B-1 and B-2.
-
Right click and choose Selection Properties.
-
Change the elevation to 1.25 inches.
-
Select the profile polyline between B.8-1 and C-2.
-
Turn on Snap Nearest Snapable Point (
) .
-
Choose the Stretch tool (
).
-
Stretch the end of the profile polyline at C-2 to approximatley mid way between lines 1 and 2.
-
Right click and choose Selection Properties.
-
Change the Elevation Reference to Above Soffit and the Elevation to 6 inches, and click OK.
-
Choose the Profile Polyline tool (
).
-
Turn off Snap Nearest Snapable Point () .
-
Turn on Snap to Point (
).
Proceed immediately to
"Define the longitude profile polylines Pt. 3".
