Define the longitude tendons Pt. 4
-
With the Half Span Tendon Panel tool () selected, draw tendons that terminate in this panel:
- Turn on Snap Orthogonal ().
- Click at the profile point at 19, 17.5 m.
- Type r0,2.1.
- Click at the last tendon profile point at 22, 17.5 m.
- In the Tendon Panel dialog box:
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, set Profile at end 2 to 125 mm, and click OK.
- With the Select Connected Tendons tool () selected, double-click the tendon on grid 2.
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, change Strands Per Tendon to 10, and click OK.
- With the Select Connected Tendons tool () selected, double-click the tendon directly to the left of grid 2.
- Hold down <Shift> and double-click the tendon directly to the right of grid 2.
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, change Strands Per Tendon to 5, and click OK. The longitude tendons are drawn but you need to adjust a number of profile points. Any profile point at the end of a tendon should be at the mid-depth of the 250 mm slab.