Viewing frequently used results
In general, using plans is the most useful way to view results. Most results of interest relate to the following:
- reinforcement quantities
- status
- deflections
- support reactions
- precompression
- load balance
- bending moment contours
- section stresses (for some codes)
- punching shear
- bearing pressures
This section explains how to find such results.
Note: When you create a new file without using a template, the file has RAM Concept 's default new file setup. The default new file setup provides preconfigured plans to show some of the results in an organized way. You can change these plans by editing the visible objects and plots. Keep in mind that this may void or make irrelevant some of the instructions below.