Define the longitude tendons Pt. 2

Complete the steps in "Define the longitude tendons Pt. 1" before proceeding.

With the Half Span Tendon Panel tool () selected, draw tendons in the balcony:
1. Click at the center of the column at grid intersection B.8-1.
2. Click at the edge of the slab at 0, 17.8 m.
3. Click at the tendon profile point at 7.2, 17.1 m.
Note: The snap orthogonal snaps the cursor to 7.2, 17.8 m.
1. Click at the tendon profile point at 7.2, 17.1 m.
In the Tendon Panel dialog box:
1. Set Auto Connect, and click OK.
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 1 to 150 mm and Profile at end 2 to 100 mm, and click OK.
With the Selection tool (), select the two shortest of the half-span (cantilever) tendon segments.
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 1 to 100 mm, and click OK.
Note: This makes the short tendon segments flat.

Proceed immediately to "Define the longitude tendons Pt. 3".