Define the manual latitude tendons Pt. 3
- With the Selection tool (), select all of the terminated tendon segments, other than those over a drop cap, by:
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, set Profile at end 1 to 5 inches and click OK.
- With the Selection tool (), select all of the terminated tendon segments over a drop cap, by:
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, set Profile at end 1 to 15 inches and click OK.
- With the Selection tool (), double click the tendon segment at B-2.
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, set Profile at end 1 to 18.75 inches and click OK.
- With the Selection tool (), double click the tendon segment at C-2.
- Right click on the plan and choose Selection Properties from the popup menu.
- In the Properties dialog box, set Profile at end 1 to 6.75 inches, and click OK.
- With the Selection tool (), select the tendon segments between C-2 and C-3.
- Click the Calc Profile tool (). The Calc Tendon Profile dialog box appears and reports the current balance load is -2.58 kips/ft. If this is not the number then you probably selected only one tendon segment.
- Click Cancel.