Define the latitude tendons Pt. 4

Complete the steps in "Define the latitude tendons Pt. 3" before proceeding.

With the Selection tool (), select all of the terminated tendon segments, other than those over a drop cap or within the balcony slab:
1. Fence the tendon segments that end on grid 1.
2. Hold the <Shift> key down and repeat the procedure until you have selected all applicable end tendon segments (tendon segments terminating at grids 2, 3, 4 and 5).
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 1 to 125 mm and click OK.
With the Selection tool (), double click the tendon segment above B.8-1 that terminates within the 200 mm balcony slab.
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 1 to 100 mm and click OK.
With the Selection tool (), select all of the tendon segments that terminate over a drop cap, by:
1. Double clicking at grid intersection A-1.
2. Hold the <Shift> key down and double click at A-3.
3. Hold the <Shift> key down and double click at B-5.
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 1 to 375 mm and click OK.
Note: This sets the tendon anchorage profile to the centroid of the 250 mm slab, rather than the centroid of the drop cap.

Proceed immediately to "Define the latitude tendons Pt. 5".