Complete the steps in "Define the longitude tendons Pt. 4" before proceeding.
With the Selection tool (), select all of the terminated tendon segments, other than those over a drop cap or within the balcony slab:
Fence the tendon segments that end on grid A.
Hold the <Shift> key down and repeat the procedure until you have selected all applicable end tendon segments (tendon segments terminating at grids B and D).
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 1 to 125 mm and click OK.
With the Selection tool (), select all of the terminated tendon segments over a drop cap, by:
Double clicking at grid intersection A-1.
Hold the <Shift> key down and double click at A-3.
Hold the <Shift> key down and double click at B-5.
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 1 to 375 mm, and click OK.
This sets the tendon anchorage profile to the centroid of the 250 mm slab, rather than the centroid of the drop cap.
With the Selection tool (), double click the tendon segment at B-2.
Right click on the plan and choose Selection Properties from the popup menu.
In the Properties dialog box, set Profile at end 1 to 462 mm and click OK.
Finally, you need to move the tendon that goes through the opening.
Proceed immediately to "Define the longitude tendons Pt. 6".
), select all of the terminated tendon segments, other than those over a drop cap or within the balcony slab: