Section Defines Listening Settings (TCP connections)
Here you can change the port used for listening for user requests.
Setting |
Description |
---|---|
Port |
Used to set the port number for incoming TCP connections. 5800 is the default listening port. |
Name |
Used to specify the name of the service to use, in the etc\services file, if a port is not specified in the Port setting above. |
BindAddress |
Used to set the IP address to listen on for TCP connections, typically in a multi-IP address configuration where ProjectWise should be listening on a particular address. By default, this setting is commented out, and all IP addresses are listened on for TCP connections. |
BindAddressIPv6 |
Used to set the IPv6 address to listen on for TCP connections. |
BindRetryCount |
Network binding can fail if another process is using the requested port. By default, the system will attempt to retry network binding up to 5 times. To change the number of times the system can retry network binding, uncomment this setting and enter another value after the = character. |
BindRetryInterval |
By default, the interval between network binding retries is 15 seconds. To change the interval between retries, uncomment this setting, and after the = character, enter how many seconds the system should wait between retries. |
Backlog |
Used to set a socket backlog for accepting new connections. By default, the backlog used is dependent on the operating system. |