Sets the computer on which the full text index catalog for this datasource will be maintained. This list displays the list of indexing services registered with this ProjectWise Design Integration Server.

(Extraction Enabled is the label for Thumbnail Extraction and File Property Extraction. Indexing Enabled is the label for Full Text Indexing.)

You can select:

• Any ProjectWise logical (native) user account - These are the users whose account type is set to Logical. These users will be listed by name. After you select this user, enter the user's password.
• <Bentley IMS/STS (local)> - Selecting this option means that the processor will use a specific Bentley IMS account to log in to the datasource. After you select this option, you are prompted to enter the credentials of the Bentley IMS account you want to use. To use this account, the account must also exist in the datasource.
• <Windows user service account> - Selecting this option means that the processor will use the same Windows account that the ProjectWise Orchestration Framework Service runs under (specified during ProjectWise Server installation). To use this account, the account must also exist in the datasource.

In general, the value for this option should be long enough for the extraction process to complete in stress load conditions, but not too long, in the event of some processing failure. If there is a failure in processing, the processing will not start again until the end of the Retry period. That means if a failure occurs early on, for example at the tenth minute of processing, nothing will happen for the next 350 minutes, until processing is restarted.

The default value is 180, and the possible range you can set is between 10 and 1440 minutes (24 hours).

Ideal values for this field can vary from datasource to datasource, so you may want to leave the default value as is, and then adjust it accordingly based on performance results. Or, try setting a value twice bigger than a time anticipated for a single document processing under stress, or value between half an hour and an hour may be a good starting point.

Limits the amount of documents that may be passed to processing in a single document inspection pass. For large datasources, the extraction engine will process that many documents at a time, until all documents to be processed have been processed. If extractions are enabled and later you select Start Processing Now, then no more than the number of documents specified in this field will be processed at that time.

The default value is 100, and the lowest value you can set here is 1.

When text indexing is enabled and this setting is off, text extractions will run according to the defined schedule. This is the default behavior, and this is how text indexing has worked in general, prior to the introduction of this setting.

When text indexing is enabled and this setting is on, text extractions for file contents will still run according to the schedule, however text extractions for document properties will run according to the setting, Retry extraction in (minutes). For example, if your text extractions are normally set to retry every 30 minutes, then every 30 minutes the text indexing processor will search for new documents to extract document property text from, even during periods when the text indexing processor is scheduled to be sleeping.