Linear Solid

Used to create a wall like solid (rectangular section) by defining its alignment.

You can access this tool from the following:

Setting	Description
Place by	Sets the position of the line defining the alignment of the linear solid. Outside — The line is placed along the inner side of the base of the linear solid. Center — The line is placed at the center of the base of the linear solid. Inside — The line is placed along the outer side of the base of the linear solid.
Width	Defines the width of the rectangular section of the solid.
Height	Defines the height of the rectangular section of the solid.
Variable Link	Let's you use an existing variable to set the input value, defined in the Variables dialog. Note: If no variables exist, you will be alerted to create one first.
Close Element button	Closes the element such that the last point and the first point are coincident.

Key-in: CREATE POLYSOLID