Create Group
|
When checked, a new group is formed out of the two
component parts, unless it already exists.
|
Treat as one
|
If this option has been activated in the CAD system
the group is set on this selection mode.
|
With Welds
|
The weld seams are integrated into the group as
well.
|
Min. Weld Length
|
A weld seam created using this command may not be
shorter than the indicated length.
|
Gap
|
The minimum gap between these parts is specified. If
the gap is bigger than the specified value, the parts will not be welded.
The value should not be equal 0 to avoid problems
with tolerances.
|