Properties
|
Select or load the end condition type and type or
select the corresponding properties for the type.
- Type – Displays
the currently selected end condition.
Note: Some of
the parameters are different for the selected end condition type. For example,
the "User Type" will have settings both for start and end conditions.
- Load – Loads
the default standard values for the current end condition type.
- Pin Dia
(Pin Diameter) – Diameter of the pin used to bend the bar.
- Angle – The
bend angle in degrees.
- Length – The
leg length.
- Depth – The
offset dimension from the end of a
Crank to the main section of the bar.
- Tail/Leg
– The tail/leg length. A tail/leg length is
automatically calculated unless you manually enter a value using the
Override Tail.
- Override
Tail
– When checked, enables setting a custom tail leg
length.
- EC
Reduction – When checked, applies the End Condition reduction.
- Rotation
– Sets an angle to rotate the end condition.
- Rotate End
Condition
– Rotates all end conditions in 90° increments.
These properties associated with parts are taken
when the model is processed, for example the Pin Diameters will also reflect in
"Bar Bending Schedule".
|
Mechanical Device
|
When checked, the rebar end will include a
mechanical coupling device.
- Manufacturer
– Used to sets All or one of the mechanical device
manufacturers from the drop-down list.
- Type
– Used to filter the
Device list, select a device type from
the drop-down list:
- Device – Select
the device in a given type for the selected manufacture to use from the list. A
representative image of the selected device is shown to the right.
- Application –
Select the desired application location from the drop-down list:
- Reverse – When
checked, reverses the orientation of the device on the bar end.
- Screw
Type – Sets the type of screw.
- Cost – Sets the
unit cost of the device type.
|
End Preparation
|
When checked, the rebar end will have a preparation
specified for use with mechanical devices.
- Manufacturer
– Used to filter the
Type list, select a mechanical device
manufacturer from the drop-down list.
- Type
– Select a device type from the drop-down list.
- Holdback
– Set this option to include a length at the end
of the bar with no preparation, using the specified length value in the
adjacent field.
- Cost – Sets the
unit cost.
|
OK
|
Closes the dialog and save your changes.
|
Cancel
|
Closes the dialog without saving changes.
|
Help
|
Opens online help.
|