Used to set
support holes along web and flanges.
Setting | Description |
---|
Support Flange / Web
|
Defines the number, distance and orientation of the
holes on the flange or web of the Support shape.
- Horizontal
Count – Sets the number of the holes in the direction of Y-Axis of
the support shape. Default is 2.
- Horizontal
Distance – Sets the distance between the end edge of the flange of
the connect shape and the center of the first hole along the Y-Axis of the
support shape. Default is 40 or 1.6 depending of the units setting.
Note: Applicable
only when the
Joint Type is set to
Angle Shape.
- Vertical
Count – Sets the number of the holes in the direction of Support
shape. Default is 3.
- Vertical
Distance – Sets the distance between two adjacent holes along the
direction of Support shape. Default is 40 or 1.6 depending of the units
setting.
|
T-Shape Support Flange
|
Defines the distance and location of the holes in
the flanges of the Support shape when T-Shape is selected as Support type.
- Horizontal Edge
– Sets the distance between the edge of the flange of the connect shape and the
center of the first hole along the Y-Axis of the support shape. It is only
valid when the T-Shape is selected as Support type. Default is 40 or 1.6
depending of the units setting.
- Vertical
Distance – Sets the distance between two holes a`long the direction
of Support shape. It is only valid when the T-Shape is selected as Support
type. Default is 100 or 4 depending of the units setting.
|