Dimension
|
- Starting
Angle – Sets the starting angle of the circular platform. Enter a
numeric value between -360° and 360° to determine the angle. The positive
direction is counterclockwise. If you have picked start point, this item will
be calculated automatically from your specification. Otherwise it will be
initialized with default value. The default is 0° independent of the units
setting.
- Included
Angle – Sets the included angle of circular platform. Enter a
numeric value between -360° and 360° to determine the angle. Positive value
means that the platform is counterclockwise. Negative value means the platform
is clockwise. This item will be initialized automatically if start point and
end point is picked. Otherwise it will be initialized with default value. The
default is 90° independent of the units setting.
- Inside
Radius – Sets the distance between center point and inner side of
tread plate. Enter a positive value to determine the inside radius. A negative
value is to be read as its absolute value. The default is 2000 or 80 depending
on the units setting.
- Platform
Width – Sets the width of tread plate. Enter a positive value to
determine the width. A negative value is to be read as its absolute value. The
default is 800 or 30 depending on the units setting.
- Height
Offset – Sets the height offset of circular platform along Z axis.
Enter a numeric value to determine the offset. The default is 0 independent of
the units setting.
|
Side Dismount Ladder
|
- Side – Sets the
position of the side dismount ladder.
- None – no side
is disconnect. The
Edge Distance is disabled.
- One
side – the ladder is at the start end.
- Other
side – ladder is at the other end.
- Both
sides – ladder is at both, the start and end.
When choosing one side, other side or both sides, the
Edge Distance value will be validated.
- Edge
Distance – Sets the offset distance between the original starting
edge and modified starting edge. Both starting edge line and modified edge line
is parallel (Refer to the picture below). Enter a positive value less than
inside radius to determine the offset. A negative value is to be read as its
absolute value. A value more than inside radius will not be accepted. The
default is 300 or 12 depending on the units setting.
|
Internal Members
|
- (spacing) –
Sets the layout mode of internal members.
-
Equal Spacing – Disables Inner Angle, and enables rest of the
settings of Internal members.
-
Unequal Spacing – Enables Inner Angle, and disables rest of the
settings of Internal members.
- Inner
Angle – Sets the angle between internal members. An asymmetrical
distribution of internal members is possible using up to 50 fields. After
clicking this item, a list will appear showing all distances in an ascending
order. Change the entry by clicking it and entering a new value. Enter a
numeric value to determine the distance. A positive value means a
counterclockwise angle. A negative value means a clockwise angle.
- No. of
Members – Sets the number of internal members that appear in the
included angle. A positive integer determines the number. The maximum number is
50. The default is 3.
- First
Angle – Sets the angle in degree between the original starting edge
and first internal member. Enter a non-negative value to determine the
distance. Zero means first internal member distance is same as other inner
distance. A negative value is to be read as its absolute value. The default is
15°.
- Last
Angle – Sets the angle in degree between last internal member and
the original end edge. Enter a non-negative value to determine the angle. Zero
means last internal member distance is same as other inner distance. A negative
value is to be read as its absolute value. The default is 15°.
|