Web Plate
|
When checked, enables web plate settings.
- Thickness –
Sets the thickness of the Web Plates.
- Length – Sets
the length of the Web Plates.
- Flange
Offset – Sets the offset from the inside flange of the supporting
shape.
- Left/
Right / Both – Determines the placement of the Web Plates relative
to the X axis of the connecting member.
|
Stiffener
|
When checked, enables stiffener settings.
- Thickness –
Sets the thickness of the Stiffener Plates.
- Web
Offset – Sets the offset from the web of the supporting shape.
- Flange
Offset – Sets the offset from the inside flange of the supporting
shape.
- End
Offset – Sets the offset from the outer edge of the supporting
shape.
- Left/
Right / Both – Determines the placement of the Stiffener Plate
relative to the X axis of the connecting member.
|
Inner Corners
|
- Chmfer /
Fillet/ Round – Determines the type of cut for the inner corners of
the Stiffener Plates.
- Distance – Sets
the distance relating to the cut. If
0, default values are retrieved from the
ProStructures database .
|
Rat Hole
|
When checked, the flange of the connecting shape is
bevelled along the common edge with the supporting shape.
- Web
Gap – Sets the gap from the web of the connecting shape to the
supporting shape.
- Upper/
Lower Flange Gap – Sets the gap from the flanges of the connecting
shape to the supporting shape.
- Upper/
Lower Depth – Sets the depth of the bevel.
- Upper/
Lower Angle – Sets the angle of the bevel.
- Invert
(Upper/ Lower) – When checked, the bevel is inserted on the
opposite side of the flange.
- Chamfer/
Fillet/ Cope (Inserted Arc) – When checked, respective option
determines the type of cut for the access hole the bevel is inserted on the
opposite side of the flange. When the
Cope option is selected, enables the Web
Insert, Arc Depth, and Flange Inset options.
- Upper/
Lower Web Inset – Sets the value that allows the access hole to be
shifted to the right or left relative to the Web Gap.
- Upper/
Lower Arc Depth – Sets the value that allows the access hole to be
shifted to up or down relative to the flange.
- Upper/
Lower Flange Inset – Sets the value that determines the starting
point of the chamfer between the flange and access hole.
|
Weld Plates
|
When checked, places the weld plates below the
flanges. Enables setting weld plate dimensions.
- Thickness –
Sets the thickness of the Weld Plates.
- Length – Sets
the length of the Weld Plates.
- Width – Sets
the width of the Weld Plates.
Note: This option is
only available when
Moment plates are not used.
|