Plate Editor - Edges tab

Setting	Description
Position	Top Side - When, on edge processing is made to the top edges of the plate. Bottom Side - When, on edge processing is made to the top edges of the plate. (Chamfer plate) - Used to select the edges on a plate to add a chamfers. The chamfer input fields are activated so you can change the layout of the chamfer.
Top/Lower edge	The following parameters are valid both for top and bottom side of the plate. Chamfer Layout - Selects the method of edge processing: Var1 - Sets either the length of the first edge, the rounding radius or the depth of the seam. Var2 - Sets either the length of the second edge or the height of the seam. Selected edge - Used to indicate from which edge to which edge the processing is applied. When you select the edge, and the side is switched on, the edges are displayed numerically. You can select the processing area. If the starting value is equal to the end value, the processing is applied all around.

Setting

Description

Position

Top Side - When, on edge processing is made to the top edges of the plate.
Bottom Side - When, on edge processing is made to the top edges of the plate.
(Chamfer plate) - Used to select the edges on a plate to add a chamfers. The chamfer input fields are activated so you can change the layout of the chamfer.

Top/Lower edge

The following parameters are valid both for top and bottom side of the plate.

Chamfer Layout - Selects the method of edge processing:
Var1 - Sets either the length of the first edge, the rounding radius or the depth of the seam.
Var2 - Sets either the length of the second edge or the height of the seam.
Selected edge - Used to indicate from which edge to which edge the processing is applied.
When you select the edge, and the side is switched on, the edges are displayed numerically. You can select the processing area. If the starting value is equal to the end value, the processing is applied all around.