| Min. segment length
|
Sets the minimum segment length (distance from one
post to the other) from which on filler rods are created.
|
| Edge distance
|
Sets the distance between the center of the first and
last filler rod and the center of the corresponding next handrail post.
|
| Distance between
|
Sets the intermediate distance between the center of
two filler rods; this value can be corrected depending on the segment length.
|
| Offset top
|
Sets the distance between the filler rods and the
insertion position at upper rail.
|
| Offset bottom
|
Sets the distance between the filler rods and the
insertion position at lower rail.
|
| Insert offset
|
Sets the filler rod offset from insertion plane
towards the front or back side.
|
| Insert from / Insert until
|
Sets the positions the filler rods starting from
(upper insertion position).
- Handrail
- Upper rail
- Middle rail
|
| Insertion until
|
Sets the position the filler rods terminate to (lower
insertion position).
- Upper rail
- Middle rail
- Lower rail
|
| Insertion position
|
Sets the depth position of the filler rods towards
the knee-high guardrails.
- Back – at rear edge
- Centered – at center
- Front –at front edge
From the possible insertion planes a widest rail is used as
reference.
|
| Cut at
|
Sets the cutting plane the bordering edge of the
knee-high guardrails or handrail the insertion points of filler rods refer to.
- Center
- Inner Edge
- Outer Edge
|
| If Collision
|
Indicates how to treat a possible collision
between filler rods and knee-high guardrails (e. g. in case of center
position).
- Ignore –
The collision is ignored.
- Divide
– The filler rod is divided at the knee-high guardrails. Any information about
distances top/bottom is taken into consideration anew for each divided rod.
- Drill
Through – The knee-high guardrails are perforated so that the filler rod can
run through it.
|
