Bolts
|
- Bolt
Type – Sets the bolt type from the installed bolt database's.
Select the required bolt type from the list. The default is the first type in
the list.
- Flip
Bolt – When checked, flips the direction of bolts that connect the
cleat and connecting shapes.
|
Holes
|
- Diameter – Sets
the diameter of the holes. Enter a positive value to determine the diameter.
Default is 16 or 0.6 depending on the units setting.
- Workloose –
Sets the allowance for the holes workloose for the holes. Enter a positive
value to determine the workloose. Default is 1 or 0.04 depending on the units
setting .
- Edge
Distance – Sets the distance between the center of the hole to the
stiffener plate edge in vertical direction. Enter a positive value to determine
the distance (refer to the drawing above). A negative value is to be read as
its absolute value. The default is 19 or 0.75 depending on the units setting.
- Match
Purlin – When checked, the
Edge Distance automatically matches the
Purlin shape (connecting shape) taken from Purlin database. Disables the Edge
Distance.
- AUS
Standard – Enabled when
Match Purlin is checked. Enables
matching purlin edge distance from purlin database.
|
Options
|
-
Group – When checked, creates group for connecting member with clip
angle. The selected shape, plates, stiffeners and bolts are arranged to form a
group. If the selected shape is already part of an existing group then the
created objects are added to that group.
- With
Bolts – Enabled for
Group. When checked, the bolts are added to
that group.
|