NC Data - Data - Marking Attached Part tab
Used to set the attached part marking and drawing options on a member profile.
Attached Parts Data settings are used to mark attached parts data.
Setting | Description |
---|---|
Mark Attached Parts | When checked (default), enables the controls within
this group used for tolerances, drawing, and marking options.
When checked, the attached part marking data is not written to the output file |
Draw Options | Used to select the way the attached part boundary is
to be marked on the main part.
Default value: Draw profile boundary |
Marking options | Used to select the method of marking the attached part profile. |
Tolerances | Sets maximum allowable gap and clash between main
part and attached part.
Default value: 1/16" (Imperial Units), 2mm (Metric units) |
Write Attached Part Information | When checked (default), the attached part Information (as labeled using the Text field) is written on the main part and text height. |
Text | Shows an expression for the attached part name to be
written to the output file.
You can change the expression by
using the
expression builder.
Default value: %Attached Part Position Number% |
Text height | The text height of the attached part name written on
the main part.
Default value: 1/4" (Imperial Units), 5mm (Metric units) |