Used to specify settings for shape labeling in the 3D
model.
Setting | Description |
---|
Sketch Size
|
Sete the calculation method for the sketch length. Select a
parameter in the drop-down list and type a corresponding value in the
Value field.
- Sketch
Length – Type the length of sketch display from the center in the
Value input field below to outline the
shape as solid. If you enter the value 0, the result will only be a
cross-section display at the center.
- End
Offset – Type the distance of the end points of the displayed
system line towards the actual insertion points in the
Value input field below.
- Relative
Length in % – Type the relative size of sketch display related to
the overall length of the shape in the
Value input field below.
|
Layout
|
Sets the layout method; one of the lines used for
sketch line:
-
Centerline - The middle line of the
shape is displayed as system line.
-
Insertion Line - The insertion line of
the shape is displayed as system line of the shape (which could for example be
the upper edge).
|
End Offset
|
Sets the end offset of the sketch lines to the shape
endpoints. This is the relative size of sketch display related to the overall
length of the shape in the Value input field above.
|