Top Holes / Bottom Holes.. in Length Direction
|
- With
Holes in Length - Enables settings for holes in length direction.
- Length - No
Holes – Sets the number of whole on length side of the plate.
- Diameter – Sets
the diameter of the hole.
- End
Edge Distance – Sets the distance of exterior holes from the end
edge.
- Gause
Distance – Sets the position of center of hole from the plate edge.
Preferably set less than radius of the hole.
|
Top Hole / Bottom Holes.. in Width Direction
|
- With
Holes in Width - Enables settings for holes in width direction.
- Width
- No Holes – Sets the number of whole on width side of the plate.
- Diameter – Sets
the diameter of the hole.
- End
Edge Distance – Sets the distance of exterior holes from the end
edge.
- Gause
Distance – Sets the position of center of hole from the plate edge.
Preferably set less than radius of the hole.
|