Extending Rebar
To extend rebar:
- Select (Extend Rebar)
-
On your model, either:
Click to identify the bar that you want to extend.
or
<Ctrl+click> on a bar to extend all bars in the same zone (such as the top, bottom, or side of a rebar cage).
- P – By Points; allows you to select first, followed by second point on the rebar.
- R – By Perpendicular Points; allows you to select a perpendicular point in the vew.
- L – By Line intersecting rebar; allows you to select the line.
- For Points, for example click to indicate the location on the bar where the bar should be extended, followed by click to identify the "new end" of the bar — the location where the bar should be extended to. The end condition is aligned with the extension location.